Back to 4x Serial to Ethernet Terminal Evaluation Kit Ordering Page The TEV-LB1 board carries a 128x96, 4-bit RITDISPLAY RGS13128096 OLED panel. This panel is based on a SOLOMON SSD1329 controller. Related datasheets, as well as the schematic diagram for the TEV-LB1 board can be found on Tibbo website. Interconnection between the EM1000 and the panelPin #(1) | EM1000 I/O line | Panel | 5 | GPIO48 | --- | 6 | GPIO47 | --- | 7 | GPIO46 | --- | 8 | GPIO39/P4.7 | D7 | 9 | GPIO38/P4.6 | D6 | 10 | GPIO37/P4.5 | D5 | 11 | GPIO36/P4.4 | D4 | 12 | GPIO35/P4.3 | D3 | 13 | GPIO34/P4.2 | D2 | 14 | GPIO33/P4.1 | D1 | 15 | GPIO32/P4.0 | D0 | 16 | GPIO44 | RST | 17 | GPIO43 | D/C | 18 | GPIO42 | R/W | 19 | GPIO41 | E | 20 | GPIO40 | CS |
Pin number 1 on the TEV-LB1 connector. Required initialization code in Tibbo BASIC applicationFor correct panel operation, click Project, Settings, and select EM1000 or EM1000W platform. Additionally, click Customize to open a Customize Platform dialog. In the dialog, double-click the Display Panel Type line and choose Solomon SSD1329 (Ritdisplay RGS13128096). The following initialization code should also be added to your project:
lcd.iomapping = 44,43,42,41,40,4 RST,DC,WR,RD,CS,data_bus (W is marked R/W on the schematic diagram, RD is marked E) io.num=PL_IO_NUM_40 io.enabled=YES io.num=PL_IO_NUM_41 io.enabled=YES io.num=PL_IO_NUM_42 io.enabled=YES io.num=PL_IO_NUM_43 io.enabled=YES io.num=PL_IO_NUM_44 io.enabled=YES lcd.width=128 lcd.height=96 lcd.rotated=NO lcd.inverted=NO lcd.enabled=YES
Back to 4x Serial to Ethernet Terminal Evaluation Kit Ordering Page
|