Philips LPC2214 (ARM) Ethernet Board with LCD, USB

Philips LPC2214 (ARM) Ethernet Board with LCD, USB, RS232, SD	US$35.13
LPC-E2214

Philips LPC2214 (ARM) Ethernet Board with LCD, USB, RS232, SD

Hardware Rev. B

LPC2214 Ethernet Board Features

MCU: 16/32-bit NXP LPC2214 ARM7TDMI-S with 256 kBytes Program Flash, 16 kBytes RAM, External Memory Bus, RTC, 8x 10-bit ADC 2.44 µS, 2x UARTs, I2C, 2x SPI, 2x 32-bit Timers with 4 capture and 4 compare channels, 6x PWM, WDT, 5V tolerant I/O, up to 60 MHz operation
1MB (256K x 32 bit) 12 ns 71V416 SRAM
1MB (512K x 16 bit) 55 ns MX26LV800BTC Flash
Standard JTAG connector with ARM 2x10 layout for programming and debugging with ARM-JTAG
Powered through USB port or via external 6V AC / 9V DC supply
USB-to-RS232 converter
Ethernet controller with Davicom DM9000E and RJ45 connector
SD/MMC slot (on bottom side; not pictured)
RESET circuit can be controlled externally by Philips ISP utility via USB-RS232 virtual port
Jumper setting to boot from external memory
Jumper setting for ISP/RUN mode selection
16x2 LCD with backlight
Two pushbuttons
Potentiometer connected to ADC
Universal extension connector (see below)
RS232 driver and connector
I2C 24LC515 EEPROM on board
Two on-board voltage regulators: 1.8V and 3.3V with up to 800mA current

Add-on UEXT Modules Available

This board has a universal extension connector, UEXT, which allows you to add a peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. Please see the UEXT Boards Category for a full list of modules that can plug into the UEXT port.

LPC2214 Ethernet Board Resources

LPC2214/2294 Ethernet Board Documentation (PDF file; 158kB)

Ethernet Board Schematic (for the LPC-E2294, which is the same design but adds 4x CAN controllers and connectors)

Test software and basic routines for access to external Flash/SRAM

OpenOCD + Eclipse set of projects 1.00. See the complete list of projects included here.

This board is a low-cost tool with limited support. It does not ship with any documentation or software; use the links above.

Ships from: USA
Leadtime: In stock

Optional Recommended Products for this Item

USB 2.0 Cable, 6ft., A-Male / B-Male	+	US$6.00
Serial Cable, 6ft., DB9 M/F	+	US$6.00
Ethernet Cable, CAT5E 350MHz Unshielded, 7ft.	+	US$3.60
Ethernet Crossover Cable, CAT5E 350MHz Unshielded, 5ft.	+	US$7.00
RF 2.4GHz Transceiver Module with NRF24L01, 125 RF Channels	+	US$5.00
3-Axis Accelerometer Board, 2/4/8 g, 25-1500Hz	+	US$5.93
Power Supply 3-12V DC, U.S. plug, 6 connection tips	+	US$10.00
Power Supply 3-12V DC, US/UK/Euro/AU Plugs, 100-240VAC	+	US$10.90