MicroController Pros Home Page My Account  Cart Contents  Checkout  

****Note: As of 11/11/2023 we no longer process and ship international orders. Only orders from USA and Canada are now accepted.****

  Store » Wireless » WiFi » Modules » MOD-WIFI-ESP8266-D My Account  |  Cart Contents  |  Checkout   
Quick Find
Enter keywords to find the product you are looking for in the Quick Find field above

or use
Advanced Search
Accessory Boards->
ADI Blackfin
Atmel AVR->
Cypress PSoC
Microchip PIC->
Silicon Labs
ST Microelectronics->
Texas Instruments->
Embedded Ethernet->
Embedded Software->
I/O Modules->
Parts & Components->
Pick & Place Tools
Programmable Logic (PLD)
Prototype PCBs->
ROM/Flash Emulators
Test & Measurement->
Tutorial Software
Universal Programmers->
  434MHz & 2.4GHz
Intro to Embedded Tools
Embedded News Digest
Useful Resources
Shipping & Returns
Warranty & Liability
Privacy Notice
Conditions of Use
Contact Us
ESP8266 WiFi Module Breakout Board, Through-Hole and Stamp-Hole US$4.95

ESP8266 WiFi Module Breakout Board, Through-Hole and Stamp-Hole

MOD-WIFI-ESP8266-DEV is a development board for the ESP8266 WiFi SoC. All GPIOs and resources are exposed in both through-hole and stamp-hole interfaces, so you can use it with a breadboard or solder it to a PCB. A W25Q16B SPI Flash memory IC is already provided to run the SoC. The board has a PCB trace antenna as well as a U.FL connector in case you want to use an external antenna.

Solder jumpers allow you to choose which antenna option to use, and to do some I/O configuration (refer to the schematic for details).

There also are pads where you could install a UEXT connector, but if UEXT is what you're after, you might consider the MOD-WIFI-ESP8266 which has a UEXT connector already installed (but does have the through-hole or stamp-hole interfaces).

Evaluation Board Available

If you want a ready-made evaluation board, consider the ESP8266-EVB, which includes this module plus a host PCB with a relay, a button, a UEXT connector, a power input jack, and GPIO headers.

Espressif ESP8266 Features

The ESP8266 is very highly integrated SoC that includes an Xtensa LX106 core processor, RAM, and RF front-end allowing a WiFi TCP/IP stack to be implemented on board with just a few components. Since it found its way to the English-speaking world in the fall of 2014 it has attracted a lot of attention there's even an Arduino IDE for it now. Its features include:
  • 802.11 b/g/n
  • Wi-Fi Direct (P2P), soft-AP
  • Integrated TCP/IP protocol stack
  • Integrated RF switch, balun, LNA, 24dBm power amplifier and matching network
  • Integrated PLLs, regulators, DCXO and power management units
  • +19.5dBm output power in 802.11b mode
  • Power down leakage current of less than 10A
  • Integrated low-power 32-bit CPU could be used as application processor
  • SDIO 1.1/2.0, SPI, UART
  • STBC, 11 MIMO, 21 MIMO
  • A-MPDU & A-MSDU aggregation & 0.4ms guard interval
  • Wake up and transmit packets in less than 2ms
  • Standby power consumption of less than 1.0mW (DTIM3)
  • Integrated RISC processor, on-chip memory and external memory interfaces
  • Integrated MAC/baseband processors
  • Quality of Service management
  • I2S interface for high-fidelity audio applications
  • On-chip low-dropout linear regulators for all internal supplies
  • Proprietary spurious-free clock generation architecture
  • Integrated WEP, TKIP, AES, and WAPI engines

ESP8266 Development Board Resources

Note: Because this module is designed for inclusion in a larger device, it does not have FCC or CE certification of its own.

This product was added to our catalog on Friday 05 December, 2014.


Customers who bought this product also purchased
ATmega168 DIP Module, ISP Connector, Arduino BootloaderATmega168 DIP Module, ISP Connector, Arduino BootloaderUS$10.00

PIC Development Module for 8- to 28-pin SOIC @ 1.27mm pitchPIC Development Module for 8- to 28-pin SOIC @ 1.27mm pitchUS$15.00

FLEX RS232 ModuleFLEX RS232 ModuleUS$9.00

FLEX CAN ModuleFLEX CAN ModuleUS$5.00

FLEX RS422 ModuleFLEX RS422 ModuleUS$3.00

Fox ZigBee, RS485 and MMC/SD Card Add-On boardFox ZigBee, RS485 and MMC/SD Card Add-On boardUS$12.00

Shopping Cart more
0 items
What's New? more
Level Shifter Board, 1.8V/3.3V/5V, 2 Circuits, I2C or SMBus
Level Shifter Board, 1.8V/3.3V/5V, 2 Circuits, I2C or SMBus
Tell A Friend

Tell someone you know about this product.
Notifications more
NotificationsNotify me of updates to ESP8266 WiFi Module Breakout Board, Through-Hole and Stamp-Hole
Reviews more
Write ReviewWrite a review on this product!
  Saturday 09 December, 2023   List of all our Products

Copyright © 2003-2017 MicroController Pros LLC
Powered by osCommerce