This is a simple breakout board for ID-Innovations RFID readers. The RFID Reader Breakout converts the 2mm pins to breadboard-friendly 0.1" headers. You can solder on an ID-3LA, an ID-12LA or an ID-20LA or use 2mm sockets if you have them.
Note: This breakout board's edges actually fit flush within the underside the ID-12LA. The board also works with the ID-20LA, but is smaller than the edges.
Each pin of the RFID reader has been broken out: VCC, READ, D0, D1, FORM, TIR, CP, both ANTs, RES, and GND. The board has four half-mounting holes for securing your project.
Example usage with ID-12LA:
RFID Reader Breakout Resources
Optional Recommended Products for this Item