The OLIMEXINO-NANO is a tiny board with an Atmel ATmega32U4 AVR microcontroller which is loaded with Arduino Leonardo firmware. It can be programmed via a micro-USB cable in the same way as the standard Arduino Leonardo, and features both a microSD card slot (on the bottom side) and a UEXT connector in addition to a proprietary miniature shield interface.
The miniature shield interface allows you to plug in and stack mini shields in the same way you would on a full-sized Arduino with full-sized shields. You can see compatible mini shields in the Optional Recommended Products list below.
The UEXT connector allows you to add another peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. There are dozens of UEXT modules available. Please see the UEXT Boards Category for a full list.
Tiny Arduino Leonardo Compatible Board Features
- ATmega32U4 MCU with Arduino Leonardo firmware
- Works with the Arduino IDE
- User button
- Reset button
- microSD card slot
- Connectors for stackable mini shields
- UEXT connector
- Intelligent power supply can take power from USB or via external battery (such as the optional Battery Shield)
- Ultra-low-power design for battery-powered, handheld or worn applications
- Dimensions: 30 × 30 × 8 mm (not counting UEXT connector)
Stacking Shields The following picture shows this OLIMEXINO-NANO with the OLIMEXINO-NANO-BB (Breadboard Connector Shield) on it, then the OLIMEXINO-NANO-BAT (Battery Shield) stacked onto the Breadboard Connector Shield. The Breadboard Connector Shield is then plugged into a Solderless Breadboard.
Power options Instead of being tethered to a PC, you can use the TOL-11456 (1A) or WA-USB-2A wall-mount supplies which use a USB cable for power delivery. The optional OLIMEXINO-NANO Battery Shield gives you a choice between using a coin cell battery or a LiPo battery, or even a barrel jack adapter for that shield's JST connector. The shield, batteries and adapters can be selected in the Optional Recommended Products list below. Just remember that the batteries and the JST adapters can't be used directly on this board; they require the Battery Shield which also is in the list.
Tiny Arduino Leonardo Compatible Board Resources
Optional Recommended Products for this Item
|USB 2.0 Cable, 6ft. A-Male / Micro-USB (5-pin) B-Male||+|| US$6.00|
|OLIMEXINO-NANO GSM/GPRS/Bluetooth 3.0+EDR Shield, SIM800H||+|| US$12.50|
|OLIMEXINO-NANO Breadboard Connector Shield||+|| US$5.00|
|Solderless Breadboard, 2x Power Bus, 400 Points, Opaque White||+|| US$3.00|
|OLIMEXINO-NANO Battery Shield||+|| US$4.00|
|CR2032 Coin Cell Battery, 20mm, 3V, 250mAh||+|| US$0.95|
|Polymer Lithium Ion Battery, 2000mAh, JST Connector||+|| US$6.95|
|2-pin Female JST Connector, 2mm pitch, with 5-inch Wires||+|| US$0.55|