This kit contains all the parts for you to build a Tibbo Project Box which serves as an enclosure for the Size 2 Tibbo Project PCB. The box includes wall-mounting holes. With optional hardware, it can be mounted on a DIN Rail instead.
There are two box kits that support the Size 2 PCB. This version is best for building a device that will not have direct human interface. It includes two paper inserts for you to write the interface information, and two plastic covers to protect those inserts.
View of assembled box
For HMI applications, see the TPB2L-KIT which includes a 3.5" 320×240 TFT LCD plus four-button keypad that will fit on top instead.
Tibbo Project System Box 2 Kit Contents This kit includes top and bottom covers, left and right side walls, status LED light guide, screws, a plug-in PCB for Reset/MD buttons, as well as paper inserts with transparent covers for marking wires and cables. Seven blank C Tibbit shells are included which you can install wherever your system does not have an actual C Tibbit in place. These blank shells ensure you can enclose the front and back sides of the box — even if your system has no C Tibbits.
- Top cover
- Bottom cover
- Left side wall
- Right side wall
- LED light guide (plastic piece that tunnels LED light from PCB to top of box)
- 4 main screws
- 4 PCB screws
- 2 paper inserts (for marking Tibbits, connectors, wires, etc.)
- 2 transparent paper insert covers
- RST/MD button PCB (plugs into your TPP2 board)
- 7 blank "C" Tibbit shells (PM12P1001-03)
Optional parts Below, you can select a couple of optional parts. One is a Vibration Protection Kit to ensure your Tibbits stay in place. The other is a DIN Rail Mounting Kit so you can secure your finished system to your DIN Rail.
Optional Recommended Products for this Item