0.5mm Pitch 10/28-pin SOIC-to-DIP Adapters and Arduino Shield Kit This kit allows you to design and build an Arduino shield that will use surface-mount chips in 0.5mm-pitch SO10 and/or SO28 packages — without needing any expert soldering skills. The kit is a combination of the 0.5mm Pitch 10/28-pin SOIC-to-DIP Adapter PCBs and the Arduino Shield Prototyping Kit. SOIC-to-DIP Adapter Features This is a strip of two SOIC-to-DIP adapters with a twist. These have the patented Schmartboard|ez technology to make soldering surface-mount devices easy. Your SMT part will sit in grooves that hold it in place and already have solder in them. So all you need to do is put a chip in the grooves, apply flux, and use a small enough soldering tip. The adapters ship as a single PCB that can be snapped apart easily, creating two individual boards: - One for 10-pin SOIC at 0.5mm pitch
- One for 28-pin SOIC at 0.5mm pitch
The 28-pin board also includes room for 0805 SMT components (e.g. a bypass capacitor), and both boards have pads for easy access to ground. A strip of 40 male pin headers is included. This strip also can be snapped apart so that you can create the individual segments needed when these boards have been separated. Arduino Shield Prototyping Board Features This prototyping board features an offset through-hole pattern that provides you with greater flexibility than standard through-hole boards. This kit includes all the basic components most Arduino shields need (stackable headers, LEDs, buttons, resistors, capacitor), plus a 170-point solderless breadboard. The Arduino headers are R3 compatible, and provided in both the Arduino offset and "corrected" 0.1-inch pitch. This allows you to make your shield compatible with either or both the official and third-party Arduino systems. Arduino Shield & SMT Prototyping Kit Resources Additional kits are available that include other SMT-to-DIP adapters.
|
