This is a downstream E-blocks peripheral module, designed to be controlled by one of the upstream E-blocks processing boards which are available in a variety of MCU/CPLD architectures. 8 individual servo channels Standard 3-pin servo motor interfaces Provides power and ground to servo motors Works with any 5V system Pads available to install components for supporting non-5V systems This E-Block allows up to eight servo motors to be connected to an E-Blocks system for use with the Flowcode Servo component. Up to eight channels can be controlled individually for connection to devices such as servo motors or brushless electronic speed controllers. E-Blocks Servo Board Resources E-Blocks Overview E-Blocks are small circuit boards each of which contains a block of electronics that you would typically find in an electronic system. Each E-Block performs a separate function as either an input sub-system, an output sub-system, an input/output sub-system or a processing sub-system. E-Blocks can be put together to form a variety of systems that can be used for teaching and learning electronics, and for the rapid prototyping of complex electronic systems. Each E-Block has one or more 9-way D-type connectors that provide up to eight input/output lines and a ground line. These D-type connectors allow connection between E-Blocks to be made in buses of multiples of 8 lines, just like a real electronic system. Power is routed separately to those E-Blocks that need it. Processing E-Blocks based on PIC, dsPIC, ARM or AVR microcontrollers control the whole E-Blocks system. Processing E-Blocks provide up to five input/output ports with up to eight lines per port. Please see the E-Blocks Category for a list of available components. For more details on E-Blocks, see the E-Blocks User Guide (in English, French, German and Spanish) or watch the Introduction to E-Blocks video.
|
