Connector for 4-wire resistive touchpanel flexible flat cables 4-wire resistive touchpanel controller circuit Standard 0.1" pin pitch for use on prototyping breadboards Mounting holes for easy integration into your final device The TouchPanel Controller PROTO Board features a 4-wire resistive analog touchpanel controller. When two resistive foils of a touch panel are connected, this controller creates output voltage levels which can be decoded to get precise x and y coordinates of the pressure point. The board features a connector for a 4-wire touchpanel flat cable (FFC), and soldering pads for an interface to prototyping boards. The connection pads are unpopulated, so you can decide how to connect the board to your system. Male header pins are provided that you can solder, for typical breadboard use. Note: This board uses 5V power supply only. TouchPanel Controller Board Resources A display with a compatible touchpanel can be selected in the options below. This board allows you to connect and control the touchpanel part only. To connect or control the display itself, you may want to purchase a Display Connector Board or a Display Serial Controller Board.
|