Prototyping PCB for 14- and 18-pin Microchip PIC Microcontrollers with RS232 Port, Status LED, 6-pin single row (Olimex) and RJ12 (Microchip) ICSP connectors, 3.3V & 5.0V Power Supply Circuit and exchangeable Crystal Oscillator Circuit PIC Prototype Board Features - Ships completely assembled and tested
- 14-pin and 18-pin DIL microcontroller sockets
- Jumper Selectable +3.3V/5.0V board supply voltage
- Power plug-in jack: 5.5mm outer, 2.5mm inner diameter
- Accepts AC and DC input voltage
- Minimum Input voltage should be 2.0VDC or 1.5VAC higher than desired board supply voltage
- Maximum Input voltage 12VDC or 9VAC
- RS232 DB9 female connector with MAX2232 interface circuit and Tx, Rx, CTS, DTR/RTS signals
- Rx and Tx pins are connected to PIC UART pins (check schematic for pin compatibility with PIC device of your choice)
- Connect CTS,DTR/RTS signals to general I/O pins of your choice
- MAX2232 provides reliable RS232 at 3.3V and 5.0V board Vcc
- 6-pin single row (top view) and RJ12 ICSP/ICD connectors for in-circuit programming and debugging
- 20 MHz quartz crystal oscillator in machined, spring loaded socket for easy replacement
- Reset button
- Push button connected to RB0 (DIP18) and RC3 (DIP14), can be connected/disconnected via jumper
- Status LED connected to RB3 (DIP18) and RC2 (DIP14) via removable jumper
- Extension solder pads for every µC pin
- Grid 100 mils
- GND bus
- Vcc bus
- FR-4, 1.5 mm (0.062"), single layer, electroless nickel/immersion gold (ENIG) plating, green soldermask, white silkscreen component print
- Four mounting holes
This prototype board is intended as a low-cost tool with limited support. It does not ship with any documentation or software. Download PIC Prototype Board Schematic Download PIC Prototype Board User Manual Ships From: USA Leadtime: In stock
Optional Recommended Products for this Item
|