Prototype board with two 12-pin terminal block connectors, two iMOD sockets, eight LEDs, fully assembled. This is an assembled prototyping board for the Netcruzer SBC66 line of Single-Board Computers. The SBC66 mounts onto it via the daughterboard connector on the SBC66. (SBC66 board is not included.) All port pins of the SBC66 board are marked clearly on the prototyping area. This board also has two ports for adding iMod Modules (see details below). The picture below shows this board with an SBC66EC plugged into it.
 Two 12-pin terminal block connectors are included for your application. The board has eight red LEDs connected to a shift register and controlled by just three port pins (Y3, Y4, Y5). As well as a Reset button, there is a Firmware button that can be used to put the SBC66 into Bootloader mode. An enclosure option is available. iMod Ports This board has two ports for the adding of plug-and-play iMod Modules. Modules of the following pin widths can be connected to the ports: - iMod Port 1 supports a 0.7" or 0.9" module.
- iMod Port 2 supports a 0.6" or 0.7" module.
- Ports 1 and 2 together support a 1.6" or 1.8" module.
Note that 1.1" modules are not supported by this board. Download PT66EI-24P User Manual and Schematics Download PT66EI-24P schematics and PCB layout files for Eagle Enclosure Option It is necessary to have an SBC66 mainboard connected to this board, then together they can fit optionally into a modified RM2015S enclosure, called ENC2015S-NZ.
If you would like to create such an enclosed system, we have a single order page from which you can purchase this board with an enclosure.
|
