The Ether I/O 24 is an integrated, microcontroller-based network interface board with 24 digital user I/O lines. The module's firmware and hardware enable your devices or other modules to be connected to a generic Ethernet network and controlled using a command sent over the network via UDP. Each of the 24 User I/O lines operates at 5V DC maximum levels and can be programmed independently as an Input whose state can be sensed remotely via another network device, as an Input whose state is checked internally and transmitted when a change occurs, or as an Output whose state can be controlled remotely by another networked device. Digital I/O over Ethernet Control Board Features - Supports ARP, BOOTP, DHCP, ICMP and UDP/IP Protocols
- Industry standard 10BaseT Ethernet Interface with an industry standard RJ-45 Connector
- 24 independently programmable signal lines with configurable CMOS, TTL or Schmitt Trigger thresholds and programmable pull-ups per line
- 50-pin Dual In-Line Package Ideal for prototyping
- Compact module fits into a standard 50-pin 900mil IC Socket (69mm x 25.2mm x 21mm)
- Advanced configuration allows the modules to scan the input ports automatically and transmit changes directly to another ETHER I/O module without host connection, or to any internet port by router connection
- On-board EEPROM allows all ports to power up in a user-programmable state
- Programmable Fixed IP or Dynamic IP assignment from a DHCP server
- Small packet size and connectionless protocol allows for real-time sensing and control
- Can be connected to a wireless network gateway or access point for wireless operation
- Low Power consumption -- only 1.1W fully operational
Digital I/O over Ethernet Control Board Resources
|
