MicroController Pros Home Page My Account  Cart Contents  Checkout  
  Store » Accessory Boards » mikroElektronika Boards » mikroBUS » MIKROE-1909 My Account  |  Cart Contents  |  Checkout   
Quick Find
Enter keywords to find the product you are looking for in the Quick Find field above

or use
Advanced Search
Accessory Boards->
  BiPOM Boards
  iMod Boards
  mikroElektronika Boards->
  UEXT Boards
ADI Blackfin
Atmel AVR->
Cypress PSoC
Microchip PIC->
Silicon Labs
ST Microelectronics->
Texas Instruments->
Embedded Ethernet->
Embedded Software->
I/O Modules->
Parts & Components->
Pick & Place Tools
Programmable Logic (PLD)
Prototype PCBs->
ROM/Flash Emulators
Test & Measurement->
Tutorial Software
Universal Programmers->
Intro to Embedded Tools
Embedded News Digest
Useful Resources
Shipping & Returns
Warranty & Liability
Privacy Notice
Conditions of Use
Contact Us
EEPROM mikroBUS Module, M95M02-DR, 2 Mbits, SPI (EEPROM 2 click) US$22.00

EEPROM mikroBUS Module, M95M02-DR, 2 Mbits, SPI (EEPROM 2 click)

  • 2 megabits of memory (256 kilobytes)
  • Write speed within 10ms (byte/page)
  • Approximately 4 million write cycles; 200 years data retention; ESD protection
  • SPI communication
  • 3.3V or 5V power supply
  • EEPROM 2 click carries ST's M95M02-DR EEPROM chip with 256KB of memory. The chip has byte and page write speeds of no more than than 10 ms. It also has the capability to write up to a page of memory in a single write cycle. So instead of writing byte by byte, retrieving the new address every time like a conventional EEPROM chip would do, this one can start from a given address and subsequent bytes will be shifted down until the end of the 256-byte page.

    The M95M02-DR is specified for more than 4 million write cycles, with more than 200 years of data retention. The memory, organized as 262144 8 bits, has an additional identification page for storing sensitive application data which can be locked permanently in read-only mode. The clock frequency is 5 MHz.

    The module communicates with your target board's MCU through the mikroBUS SPI pins (CS, SCK, MISO and MOSI). A solder jumper on the board allows you to select whether 3.3V or 5V power is used. It is in the 5V position by default. This is opposite of the default setting found on other Click boards, so be careful.

    Note: The picture shows the board with through-hole headers. The board now comes populated with male pin headers already soldered for your convenience. The board's user manual has yet to be updated to remove the soldering instructions.

    mikroBUS Click Boards Overview

    Click boards plug directly into a mikroBUS socket. mikroBUS is a specially designed plug-and-play pinout standard. The sockets are found on Clicker boards, the Flip & Click Arduino/Python-compatible board, the Quail board, these mikromedia shields, the Microchip Curiosity board, and development systems from mikroElektronika (V7 systems and later).

    You also can connect Click boards to many other popular platforms via these adapters:

    • PC Click USB Adapter (MIKROE-1433)
    • Arduino Arduino UNO click shield (MIKROE-1581) or Arduino Mega click shield (MIKROE-1900)
    • Raspberry Pi Pi click shield (MIKROE-1512) or Pi 2 click shield (MIKROE-1879)
    • BeagleBone Black BeagleBone click shield (MIKROE-1596) or mikroBUS Cape (MIKROE-1857)
    • STM32F3 Discovery STM32F3 Discovery Shield (MIKROE-1447)
    • STM32F4 Discovery STM32F4 Discovery Shield (MIKROE-1481)
    • Stellaris LM4F120 LaunchPad / Tiva TM4C123G LaunchPad Click BOOSTER PACK (MIKROE-1363)
    • Freescale Freedom — FRDM-KL46Z click shield (MIKROE-1795) or FRDM-K64F click shield (MIKROE-1794)

    In addition, it is royalty-free to add mikroBUS to your own designs. Visit the mikroBUS Category to see the full line of Click boards.

    EEPROM Add-on Module Resources

    This product was added to our catalog on Tuesday 09 February, 2016.


    Customers who bought this product also purchased
    2x 14-Segment Display, mikroBUS, Green LED (AlphaNum G click)2x 14-Segment Display, mikroBUS, Green LED (AlphaNum G click)US$19.00

    Humidity/Temperature Sensor, mikroBUS, I2C, 3.3V (HDC1000 click)Humidity/Temperature Sensor, mikroBUS, I2C, 3.3V (HDC1000 click)US$23.00

    2x mikroBUS Interface for Raspberry Pi 2B/B+ (Pi 2 click shield)2x mikroBUS Interface for Raspberry Pi 2B/B+ (Pi 2 click shield)US$8.00

    Capacitive Keypad mikroBUS Module, 4x Buttons (TouchKey click)Capacitive Keypad mikroBUS Module, 4x Buttons (TouchKey click)US$12.00

    DS18S20+ Digital Temperature Sensor, TO-92 PackageDS18S20+ Digital Temperature Sensor, TO-92 PackageUS$5.13

    Gyroscope mikroBUS Module, L3GD20, I2C or SPI, 3.3V (Gyro click)Gyroscope mikroBUS Module, L3GD20, I2C or SPI, 3.3V (Gyro click)US$25.00

    Shopping Cart more
    0 items
    What's New? more
    Flowcode 7 for PIC, AVR, Arduino, ARM - Academic Single User
    Flowcode 7 for PIC, AVR, Arduino, ARM - Academic Single User
    Specials more
    4-port USB2.0 Hub, Unpowered, ASUS Zenhub
    4-port USB2.0 Hub, Unpowered, ASUS Zenhub
    Tell A Friend

    Tell someone you know about this product.
    Notifications more
    NotificationsNotify me of updates to EEPROM mikroBUS Module, M95M02-DR, 2 Mbits, SPI (EEPROM 2 click)
    Reviews more
    Write ReviewWrite a review on this product!
      Sunday 22 September, 2019   List of all our Products

    Copyright © 2003-2017 MicroController Pros LLC
    Powered by osCommerce