This MSP430 DIP module allows you to experiment with the features of the MSP430F169 using a solderless breadboard setup. All I/O, VCC, GND, XT2 and Reset pins of the MSP430 microcontroller are available via 0.100" spaced pins at the bottom of the board, which allows you to plug this board into a solderless breadboard unit and quickly build additional circuit around it.

This MSP430 module can be programmed and debugged in-circuit via its JTAG Flexible Printed Circuit interface.

MSP430F169 Module Features

• MSP430F169 Flash processor
• TPS3838 supply voltage supervisor
• External reset via SVS manual reset option
• JTAG Flexible Printed Circuit interface (JFPC) socket for in-circuit programming and debugging
• 32 kHz crystal
• 0.100" pins for all port pins, XT2, VCC/GND and Reset
• LED on P1.0

To connect to this board using an MSP430 JTAG in-system debugger and programmer that has a standard 2x7 JTAG connector, you will need to use or build a JTAG-to-FPC adapter.

MSP430F169 Overview

• 16-bit RISC architecture
• 125 ns Instruction Cycle
• 48 I/O pins
• 60 kBytes Flash
• 2 kBytes RAM
• 3-channel Internal DMA
• 12-bit A/D Converter with Internal Reference, Sample-and-Hold, and Autoscan
• Dual 12-bit D/A Converters with Synchronization
• 16-bit Timer_A with 3 Capture/Compare Registers
• 16-bit Timer_B with 7 Capture/Compare-With-Shadow Registers
• On-chip Comparator
• USART0 Functions as Asynchronous UART, Synchronous SPI, or I2C
• USART1 Functions as Asynchronous UART or Synchronous SPI
• Brown-out Detection
• Supply Voltage Supervisor/Monitor with Programmable Level Detection
• Programmable Code Protection by Security Fuse

MSP430F169 DIP Module Resources

• B169 Plot (PDF file, 106K)
• B169 Schematic (PDF file, 22K)
• B169 Bill Of Materials (PDF file, 6K)

Available Programmers/Debuggers

Ships from: USA
Leadtime: in stock