This kit contains all the parts for you to build a Tibbo Project Box which serves as an enclosure for the Size 2 Tibbo Project PCB. The box includes wall-mounting holes. With optional hardware, it can be mounted on a DIN Rail instead. There are two box kits that support the Size 2 PCB. This version is best for building a device with a direct human interface. It includes a 3.5" 320×240 TFT LCD plus four-button keypad that will fit on top. View of assembled box  For non-HMI applications, see the TPB2-KIT which includes paper inserts (you can write connection details on them) and plastic protectors that will fit on top instead. Tibbo Project System Box 2 Kit Contents This kit includes top and bottom covers, left and right side walls, status LED light guide, screws, a plug-in PCB for Reset/MD buttons, as well as the LCD with cable, keypad with cable, and a 3M adhesive sheet to fit over the keypad. Seven blank C Tibbit shells are included which you can install wherever your system does not have an actual C Tibbit in place. These blank shells ensure you can enclose the front and back sides of the box — even if your system has no C Tibbits. Parts list - 320 × 240 resolution 3.5-inch TFT LCD
- 4-button sensor keypad
- Top cover
- Bottom cover
- Left side wall
- Right side wall
- LED light guide (plastic piece that tunnels LED light from PCB to top of box)
- 4 main screws
- 4 PCB screws
- RST/MD button PCB (plugs into your TPP2 board)
- 7 blank "C" Tibbit shells (PM12P1001-03)
Optional parts Below, you can select a couple of optional parts. One is a Vibration Protection Kit to ensure your Tibbits stay in place. The other is a DIN Rail Mounting Kit so you can secure your finished system to your DIN Rail.
Optional Recommended Products for this Item
|
