Prototype board with iMOD socket, fully assembled, with modified RM2015S enclosure.
This is basically a bundle package making it easy to create an enclosed system built around the Netcruzer SBC66 line of Single-Board Computers.
The top picture shows an assembled kit with an SBC66EC installed and the FPAN-2015S-NETUSB faceplate. An SBC66EC board is not included, and the faceplate is optional.
- PT66ECI Prototype Board
- ENC2015S-NZ Enclosure with screws and one solid back faceplate (a modified version of an RM2015S, with extra standoffs)
- PCBSP-143 spacer and SCREW-222SC440 long screw for securing SBC66 through PT66 into extra standoff
- Optionally, one additional faceplate for Ethernet/USB/iMOD side (see options below)
The SBC66 mounts onto the prototype board via the daughterboard connectors. All pins of the daughterboard connectors are available on the prototyping board, and clearly marked on the PCB.
The prototype board also has a port for adding one of the iMod Modules (of 0.7" or 0.9" width).
Download PT66ECI User Manual and Schematics Download PT66ECI schematics and PCB layout files for Eagle
The prototype board may be purchased without the enclosure.
The enclosure is a modified Hammond RM2015S. It measures 100mm (3.94") long by 130mm (5.21") wide by 30mm (1.18") high, and is constructed of durable ABS plastic. Screws are included for fastening the mated boards to the inside of the enclosure. This modified version has two additional standoffs. One standoff allows you to use the included extra long screw and spacer to secure the SBC66EC board to the PT66ECI prototype board and through to the enclosure. The other standoff provides a side mounting position for the PT66ECI as an alternative (or addition) to the standard corner mounting hole (this prototype board's small size means it does not stretch all the way across or all the way down the enclosure). The enclosure comes with one solid panel piece for the empty back side of the unit.
The picture below shows the prototyping board inside the enclosure, and with an SBC66EC secured using the extra long screw and spacer.
Faceplates Depending on whether and which iMOD module you have plugged into the board, the type of faceplate you will need for the interface side will vary. Thus you must select a faceplate (or none) specifically for the other side. Use the checkbox at the bottom of this page to select the faceplate you need. Below is a guide:
Choose this faceplate when you are not using an iMOD module.
Faceplates for use with various iMOD modules are planned but not yet available. You can, for now, leave this end of the enclosure open.
Optional Recommended Products for this Item