The EasyPULL Board is an add-on module that features eight pull-up/pull-down resistors. There are two versions of the board: select 10K or 1K resistor value at the bottom of this page (the part number on your invoice will change to MIKROE-575 or MIKROE-576 depending on your selection). Pull-up/pull-down selection is done by moving jumpers. This tool can be used to steer a pin to a known state if no input is present. This board is ideal for protecting the input pin and fixing the input pin at a valid voltage level.
An IDC10 connector and pin header are on the board, as well as through-hole pads, to enable connection with external electronic circuits.
Piggyback with EasyLED Board You can plug the EasyLED board onto the top of the EasyPULL board to provide device pins with Vcc or GND via resistors and obtain visual indication of output signals via LEDs. See the image to the right to see how the boards can be piggybacked while plugged into a mikroElektronika development system.
Download EasyPULL Schematic