MicroController Pros Home Page
My Account  Cart Contents  Checkout  
  Store » DR-JB-AVR-20 My Account  |  Cart Contents  |  Checkout   
Quick Find
 
Enter keywords to find the product you are looking for in the Quick Find field above

or use
Advanced Search
Categories
Accessory Boards->
8051->
ADI Blackfin
Arduino->
ARM->
Atmel AVR->
Cypress PSoC
Freescale->
FTDI->
Locktronics
Microchip PIC->
MIPS
Parallax->
Renesas
Silicon Labs
ST Microelectronics->
Texas Instruments->
Tibbo->
Books->
Displays->
E-Blocks->
EEPROM/EPROM/FLASH
Embedded Ethernet->
Embedded Software->
I/O Modules->
Parts & Components->
Pick & Place Tools
Programmable Logic (PLD)
Prototype PCBs->
Robotics
ROM/Flash Emulators
Test & Measurement->
Tutorial Software
Universal Programmers->
Wireless->
Information
Intro to Embedded Tools
Embedded News Digest
Useful Resources
Shipping & Returns
Warranty & Liability
Privacy Notice
Conditions of Use
Contact Us
AVR 20-pin DIP Low Cost Prototype Board w ATTiny2313 US$7.50

DR-JB-AVR-20
AVR 20-pin DIP Low Cost Prototype Board w ATTiny2313


This low cost prototyping board for 20-pin AVR microcontrollers comes mounted with an ATTiny2313 microcontroller in a 20-pin DIP socket and minimum support components, like a reset switch, crystal and power-on LED.

All microcontroller port pins are each routed to two adjacent through-hole solder pads. Dedicated solder rows for Vcc & GND help to simplify connections of your own components. A prototyping area allows you to add your own circuitry.

This board works at 3.3V or 5V DC.

Use this board for your quick experiments and prototypes.

Note: This board does not have an on-board voltage regulator. You must use this board with a regulated DC power supply. Exceeding 5.5VDC will damage the components on this board. The universal supplies shown in the options below do not have a 3.3V or 5V setting. You can use them, however, in combination with one of the 3.3V or 5V regulator boards found in the Voltage Regulators Category. That category also has some USB-sourced options.

Programming

This board has a single row, male ISP header for in-circuit programming of the microcontoller. Most AVR ISP programmer have a 2x10 or 2x6 pin ISP connector. To use such a programmer with this board, you will need an AVRISP adapter together with some prototyping wires to interface between your programmer and this board. (see add-on options below). Alternatively you could make your own ISP adapter cable. We also offer a low cost serial port AVR ISP programmer that has the matching 6-pin single row ISP connector (see add-on options below).

    AVR Prototype Board Downloads

  • AVR 20-pin DIP Prototype Board Datasheet

  • Optional Recommended Products for this Item
    Atmel AVR ISP Adapter, 10-pin to 6-pin (Atmel Butterfly)+ US$7.50
    Pack of 12 Prototyping Wires for 0.025-inch Square Pins+ US$6.90
    Rectangular Pin Header, Male, 1x40 Single Row, 2.54mm Spacing+ US$0.75
    Low Cost AVR ISP Programmer, serial port+ US$16.00
    Power Supply 3-12V DC, U.S. plug, 6 connection tips+ US$11.00
    Power Supply 3-12V DC, US/UK/Euro/AU Plugs, 100-240VAC+ US$13.00

    This product was added to our catalog on Saturday 20 June, 2009.

    Reviews

    Customers who bought this product also purchased
    5V & 3.3V Dual Voltage Output Board5V & 3.3V Dual Voltage Output BoardUS$5.50

    USB Power Regulator Board, 3.3V & 5V Ref., 0.1" Pitch (USB Reg)USB Power Regulator Board, 3.3V & 5V Ref., 0.1" Pitch (USB Reg)US$6.00

    USB-UART Converter Board, FT232R, 3.3V/5V, 0.1" Pitch (USB UART)USB-UART Converter Board, FT232R, 3.3V/5V, 0.1" Pitch (USB UART)US$9.00

    2x3 (6-pin) 0.1" pitch IDC Connector Flat Ribbon Cable, 15cm2x3 (6-pin) 0.1" pitch IDC Connector Flat Ribbon Cable, 15cmUS$1.80

    RS485 Module with 3kV Isolation, ISO35T, Full-Duplex, UEXTRS485 Module with 3kV Isolation, ISO35T, Full-Duplex, UEXTUS$23.89

    Atmel AVR Embedded Web Server BoardAtmel AVR Embedded Web Server BoardUS$51.00

    Shopping Cart more
    0 items
    What's New? more
    Flowcode 7 "Misc Pack A" Feature Pack
    Flowcode 7 "Misc Pack A" Feature Pack
    US$42.00
    Specials more
    USB Power Regulator Board, 3.3V & 5V Ref., 0.1" Pitch (USB Reg)
    USB Power Regulator Board, 3.3V & 5V Ref., 0.1" Pitch (USB Reg)
    US$6.00
    US$4.00
    Tell A Friend
     

    Tell someone you know about this product.
    Notifications more
    NotificationsNotify me of updates to AVR 20-pin DIP Low Cost Prototype Board w ATTiny2313
    Reviews more
    Write ReviewWrite a review on this product!
      Wednesday 26 April, 2017   List of all our Products

    Copyright © 2003-2017 MicroController Pros LLC
    Powered by osCommerce