This is the fantastically easy to use ultrasonic sensor from Maxbotix that allows you to easily measure distance using ultrasonic sound waves. This ultrasonic transducer features Serial, PWM and Analog interfaces. The sensor provides very accurate readings of 0 to 255 inches (0 to 6.45m) in 1-inch increments with little or no dead zone.
Maxbotix is offering the EZ0, EZ1, EZ2, EZ3, and EZ4 with progressively narrower beam angles allowing the sensor to match the application. Please see the beam width explanation below.
You can control up to 10 sensors with only two pins. See the Maxbotix FAQ listed below.
Warning: Maxbotix applies Christian symbols to their PCBs. If you live or work in a place where such symbols are forbidden (such as a school), do not buy this product, or be sure to scratch them out. The Customs offices of countries that forbid the sending of religious symbols may not accept importation of these sensors.
- 42kHz Ultrasonic sensor
- Operates from 2.5-5.5V
- Low 2mA supply current
- 20Hz reading rate
- Serial Output - 9600bps
- Analog Output - 10mV/inch
- PWM Output - 147uS/inch
- Small, light weight module
Check out Mikey Sklar's flame-based trampoline, the high-lighter, using the EZ1!
Compatible with Waspmote This sensor can be used in a Waspmote wireless sensor platform by plugging it into the Waspmote Smart Cities Sensor Board.
Optional Recommended Products for this Item