MicroController Pros Home Page
My Account  Cart Contents  Checkout  
  Store » LPC2478-STK My Account  |  Cart Contents  |  Checkout   
Quick Find
 
Enter keywords to find the product you are looking for in the Quick Find field above

or use
Advanced Search
Categories
Accessory Boards->
8051->
ADI Blackfin
Arduino->
ARM->
Atmel AVR->
Cypress PSoC
Freescale->
FTDI->
Locktronics
Microchip PIC->
MIPS
Parallax->
Renesas
Silicon Labs
ST Microelectronics->
Texas Instruments->
Tibbo->
Books->
Displays->
E-Blocks->
EEPROM/EPROM/FLASH
Embedded Ethernet->
Embedded Software->
I/O Modules->
Parts & Components->
Pick & Place Tools
Programmable Logic (PLD)
Prototype PCBs->
Robotics
ROM/Flash Emulators
Test & Measurement->
Tutorial Software
Universal Programmers->
Wireless->
Information
Intro to Embedded Tools
Embedded News Digest
Useful Resources
Shipping & Returns
Warranty & Liability
Privacy Notice
Conditions of Use
Contact Us
LPC2478 (ARM7) Board, TFT LCD, Ethernet, CAN, RS232, USB US$196.33

LPC2478-STK
LPC2478 (ARM7) Board, TFT LCD, Ethernet, CAN, RS232, USB


LPC-2478STK is a starter kit which uses the LPC2478 MCU from NXP. This powerful MCU supports various serial interfaces such as USB host, USB device, UART, CAN, etc. In addition, you will find audio input and output as well as MP3 decoder, digital accelerometer, JTAG, Ethernet, touchscreen TFT display, and SD/MMC card connector on this board. All this along with the ARM7TDMI-S architecture and uC Linux allow you to build powerful applications to be used in a wide range of situations.

Note: The image to the right shows this board with MICTOR Trace and IrDA components installed, but these are not included.

LPC2478 Development Board Features

  • MCU: LPC2478
  • LCD 3.5'' 320x200 24-bit color TFT with backlight and touchscreen (mounted on underside of board)
  • MP3 decoder DSP + codec VS1002D
  • 3-axis digital accelerometer with 11-bit accuracy
  • 64 MB SDRAM
  • USB host connector
  • USB device connector
  • PS2 keyboard connector
  • 100Mbit Ethernet
  • CAN driver and connector
  • RS232 with ICSP control
  • SD/MMC card connector
  • Standard 20-pin ARM JTAG connector
  • Reset button and circuit
  • 2 user buttons
  • 1 trimpot
  • UEXT connector (see below)
  • Audio IN
  • Audio OUT
  • RTC battery
  • FR-4, 1.5 mm, red soldermask, component print
  • Dimensions: 134.6 x 101.5mm (5.3 x 4.0'')

Add-on UEXT Modules Available

This board has a universal extension connector, UEXT, which allows you to add a peripheral module easily. The UEXT can provide I2C, RS232, SPI and power to the external device. Please see the UEXT Boards Category for a full list of modules that can plug into the UEXT port.

LPC2478 Development Board Software

The board comes pre-loaded with Uboot, and the CD contains a ucLinux image you can copy to a USB flash disk and boot. You can use GCC or a commercial ARM compiler if you want to develop without ucLinux RTOS.

LPC2478 Processor Features

  • ARM7TDMI-S processor, running at up to 72 MHz.
  • 512 kB on-chip flash program memory with In-System Programming (ISP) and In-Application Programming (IAP) capabilities. Flash program memory is on the ARM local bus for high performance CPU access.
  • 98 kB on-chip SRAM includes:
    • 64 kB of SRAM on the ARM local bus for high performance CPU access.
    • 16 kB SRAM for Ethernet interface. Can also be used as general-purpose SRAM.
    • 16 kB SRAM for general purpose DMA use also accessible by the USB.
    • 2 kB SRAM data storage powered from the RTC power domain.
  • LCD controller, supporting both Super-Twisted Nematic (STN) and Thin-Film Transistors (TFT) displays.
    • Dedicated DMA controller.
    • Selectable display resolution (up to 1024 768 pixels).
    • Supports up to 24-bit true-color mode.
  • Dual Advanced High-performance Bus (AHB) system allows simultaneous Ethernet DMA, USB DMA, and program execution from on-chip flash with no contention.
  • EMC provides support for asynchronous static memory devices such as RAM, ROM and flash, as well as dynamic memories such as Single Data Rate SDRAM.
  • Advanced Vectored Interrupt Controller (VIC), supporting up to 32 vectored interrupts.
  • General Purpose AHB DMA controller (GPDMA) that can be used with and SD/MMC interface as well as for memory-to-memory transfers.

Serial Interfaces

  • Ethernet MAC with MII/RMII interface and associated DMA controller. These functions reside on an independent AHB.
  • USB 2.0 full-speed dual-port device/host/OTG controller with on-chip PHY and associated DMA controller
  • Four UARTs with fractional baud rate generation: one with modem control I/O, one with IrDA support; all with FIFO
  • CAN controller with two channels
  • SPI controller
  • Two SSP controllers, with FIFO and multi-protocol capabilities. One is an alternate for the SPI port, sharing its interrupt. SSPs can be used with the GPDMA controller.
  • Three I2C-bus interfaces (one with open-drain and two with standard port pins).
  • I2S (Inter-IC Sound) interface for digital audio input or output. It can be used with the GPDMA.

Other peripherals

  • SD/MMC memory card interface.
  • 160 General purpose I/O pins with configurable pull-up/down resistors.
  • 10-bit ADC with input multiplexing among 8 pins.
  • 10-bit DAC.
  • Four general-purpose timers/counters with 8 capture inputs and 10 compare outputs. Each timer block has an external count input.
  • Two PWM/timer blocks with support for three-phase motor control. Each PWM has an external count inputs.
  • Real-Time Clock (RTC) with separate power domain. Clock source can be the RTC oscillator or the APB clock.
  • 2 kB SRAM powered from the RTC power pin, allowing data to be stored when the rest of the chip is powered off.
  • WatchDog Timer (WDT). The WDT can be clocked from the internal RC oscillator, the RTC oscillator, or the APB clock.

LPC2478 Development Board Resources


Optional Recommended Products for this Item
Ethernet Cable, CAT5E 350MHz Unshielded, 7ft.+ US$3.60
Ethernet Crossover Cable, CAT5E 350MHz Unshielded, 5ft.+ US$7.00
USB 2.0 Cable, 6ft., A-Male / B-Male+ US$6.00
Serial Cable, 6ft., DB9 M/F+ US$6.00
Serial Null Modem Cable, 6ft., DB9 F/F+ US$7.00
Power Supply 3-12V DC, U.S. plug, 6 connection tips+ US$11.00
Power Supply 3-12V DC, US/UK/Euro/AU Plugs, 100-240VAC+ US$13.00
White Earphones with 3.5mm Stereo Connector+ US$5.00
Portable Self-Powered Speaker, 3.5mm Plug, Li-Ion Battery+ US$14.99

This product was added to our catalog on Friday 03 October, 2008.

Reviews

Customers who bought this product also purchased
ARM JTAG Debugger & Programmer, USB 2.0, OpenOCD, High-SpeedARM JTAG Debugger & Programmer, USB 2.0, OpenOCD, High-SpeedUS$54.86

Atmel AT91SAM7X256 (ARM) Board, Color LCD, USB, 2x RS232, SD/MMCAtmel AT91SAM7X256 (ARM) Board, Color LCD, USB, 2x RS232, SD/MMCUS$76.93

AT90CAN128 Board with 160x160 B/W LCD and Touchscreen, CAN, SDAT90CAN128 Board with 160x160 B/W LCD and Touchscreen, CAN, SDUS$125.95

Atmel AVR JTAG In-Circuit Debugger & Programmer, USBAtmel AVR JTAG In-Circuit Debugger & Programmer, USBUS$27.60

Atmel AVR C-Compiler (Imagecraft)Atmel AVR C-Compiler (Imagecraft)US$249.00

48 Channel EM-506 SiRF Star IV GPS Receiver with Antenna48 Channel EM-506 SiRF Star IV GPS Receiver with AntennaUS$39.95

Shopping Cart more
0 items
What's New? more
Flowcode 7 for PIC, AVR, Arduino, ARM - Pro 2 User
Flowcode 7 for PIC, AVR, Arduino, ARM - Pro 2 User
US$400.00
Specials more
GSM/GPRS Module for Arduino
GSM/GPRS Module for Arduino
US$103.00
US$89.00
Tell A Friend
 

Tell someone you know about this product.
Notifications more
NotificationsNotify me of updates to LPC2478 (ARM7) Board, TFT LCD, Ethernet, CAN, RS232, USB
Reviews more
Write ReviewWrite a review on this product!
  Tuesday 28 March, 2017   List of all our Products

Copyright © 2003-2017 MicroController Pros LLC
Powered by osCommerce