
The high-performance Atmel picoPower ATmega88A-PU 8-bit AVR RISC-based microcontroller combines 8KB ISP Flash memory with read-while-write capabilities, 512 Bytes EEPROM, 1KB SRAM, 23 general-purpose I/O lines, 32 general-purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts, serial programmable USART, a byte-oriented 2-wire serial interface, SPI serial port, 6-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, and five software-selectable power-saving modes. The device operates between 1.8 and 5.5 volts. By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching 1 MIPS per MHz, balancing power consumption and processing speed. ATmega88A-PU AVR Microcontroller Features Advanced RISC Architecture - 131 Powerful Instructions – Most Single Clock Cycle Execution
- 32 x 8 General Purpose Working Registers
- Fully Static Operation
- Up to 20 MIPS Throughput at 20 MHz
- On-chip 2-cycle Multiplier
High-Endurance Non-volatile Memory segments - 8K Bytes of In-System Self-programmable Flash program memory
- 512 Bytes EEPROM
- 1K Bytes Internal SRAM
- Write/Erase cyles: 10,000 Flash/100,000 EEPROM
- Data retention: Less than 1 PPM over 20 years at 85°C; 100 years at 25°C
- Optional Boot Code Section with Independent Lock Bits
• In-System Programming by On-chip Boot Program • True Read-While-Write Operation - Programming Lock for Software Security
Atmel QTouch Library Support - Capacitive touch buttons, sliders and wheels
- QTouch and QMatrix acquisition
- Up to 64 sense channels
Peripheral Features - Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode
- One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
- Real-Time Counter with Separate Oscillator
- Six PWM Channels
- 6-channel 10-bit ADC; Temperature Measurement
- Programmable Serial USART
- Master/Slave SPI Serial Interface
- Byte-oriented 2-wire Serial Interface (Philips I2C compatible)
- Programmable Watchdog Timer with Separate On-chip Oscillator
- On-chip Analog Comparator
- Interrupt and Wake-up on Pin Change
Special Microcontroller Features - Power-on Reset and Programmable Brown-out Detection
- Internal Calibrated Oscillator
- External and Internal Interrupt Sources
- Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, Extended Standby
I/O and Packages - 23 Programmable I/O Lines
- 28-pin PDIP
Operating Voltage Temperature Range Speed Grades - 0 - 4 MHz @ 1.8V - 5.5V
- 0 - 10 MHz @ 2.7V - 5.5V
- 0 - 20 MHz @ 4.5V - 5.5V
Power Consumption - Active Mode: 0.2 mA at 1 MHz, 1.8V, 25 °C
- Power-Down Mode: 0.1 µA at 1 MHz, 1.8V, 25 °C
- Power-Save mode: 0.75 µA (including 32 kHz RTC) at 1 MHz, 1.8V, 25 °C
The Atmel ATmega88A Page has datasheets and other documentation. Please contact us for volume discount on orders of more than 50 pieces.
|