
BASIC STAMP 2SX Activity Kit with 2x16 LCD, Stepper Motor, serial programming cable and development software. I-Stamp Microcontroller Board Features - Compatible with BASIC Stamp 2SX module (BS2SX-IC)
- 50 MHz clock frequency
- Operate up to 10,000 P-BASIC command/second
- 16KByte memory, 100,000 times erasable
- 32 byte RAM with 64 byte Scratchpad RAM
- Consumption 65mA in full operation and 200uA in sleep mode
- In-system programming and Debugging via serial port
- 16 I/O, 30mA/30mA source/sink current
- Maximum 60mA/60mA source/sink current per 8-pin
- I/O pin can drive LED (with current limit resistor) and 6V servo motor directly
- LED power status
- Board sizes 1.7" x 1.2"
- Uses BASIC Stamp Editor software for development
AX-2SX Activity board - Supports I-Stamp
- In-system programming and Debugging via serial port
- 8-LED display
- Relay driver with relay 12V
- Uni-polar Stepper motor driver share with LED on P0-P3 of I-Stamp
- Voice-coil 8W speaker
- LDR light sensor with RC circuit
- 4-Push button switch with resistor pull-up
- Serial interface connector (P15)
- DC adapter 12V 500mA (not included)
- Polarity protection circuit
Package Contents Download BASIC Stamp 2SX Activity Kit User's Manual
Optional Recommended Products for this Item
|