This kit provides all components for learning and experimenting with the PIC16F87x microcontroller. It also supports PIC18Fxxx (in DIP package). In addition, it comes with a PX-200 ISP programmer which communicates via USB port cable, an NX-877 plus experiment board, computer cable, #22AWG jumper wire, DC adaptor, experiments user manual, software & source programs in CD.

PIC Starter Kit Features

• Supports PIC16F87x & PIC18Fxxx
• On-Board PIC16F877 running at 20MHz
• In-system programming with the PX-200 programmer, communication via USB port(included)
• Selection of RUN/PROG mode by switch
• Supplies power of +5V 500mA
• Proto board measuring 2.5x7 inches, 800 points
• RS-232 serial port interface circuit
• 1Hz- 1kHz pulse generator

• 4-Push button switch (Low while active with a pull up resistor)
• 32-channel LED Monitor
• Piezo speaker
• LCD connector with brightness control
• 4 Channel 0-5Vdc voltage source for ADC experiments
• 4 by 3 Matrix switch with pull-up capabilities
• 3-digit multiplexed LED display
• 1-Wire and 1 Button jack (For use with DS1402 - included)

The heart of this section is PIC16F877A microcontroller. It is programmed via In-System Programming (ISP) by PX-200 programmer board (included in this package) and can select operation mode (Run/Program) by a MODE switch.

Download Proto Board w keypad User Manual (PDF file; 447KB)