The Tibbo DS100B is a Serial Device Server that externally connects any existing serial device to an Ethernet (TCP/IP) network. The DS100B features a compact and stylish design and with universal RS232/422/485 serial port (available through a single DB9M connector, interface selection by DIP switch).

The DS100B Serial Device Server is internally based on the Tibbo EM100 Ethernet Module.

10Mbps Ethernet to Serial (RS232/422/485) Device Server Features

• Dimensions: 89x51x30mm
• Power requirements: 12V DC, approx. 80mA
• One 10BaseT Ethernet port
• One RS232/422/485 port (RX, TX, RTS, CTS, DTR, DSR*)
• RTS, CTS, DTR, and DSR lines can be used as remotely controlled I/O
• Four LEDs display status information
• Two internal 510-Byte routing buffers
• On-board EEPROM stores numerous user-definable functioning parameters (Setting)
• Supported network protocols include UDP, TCP, ARP, ICMP (PING) and DHCP
• Setup can be performed through the serial port or network (over-the-network IP-address configuration is also supported)
• Specialized "on-the-fly" commands for serial port control, "modem" commands to control network connections, status commands for remote status monitoring, etc.
• Internal firmware is upgradeable through the serial port or network
• Supplied with Device Server Toolkit (DST) for Windows, including Virtual Serial Port Driver (VSPD) (COM redirector)
• LINUX version of the VSPD is also available
• Works with TIBBO.NET
• CE- and FCC-approved

* In RS232 mode only. In RS422, the DS100B provides TX+/-, RX+/-, RTS+/-, CTS+/-; in RS485 mode, TX+/-, RX+/-