Three-in-one USB device combining ARM JTAG debugger, virtual RS232 port with full modem signals supported, and power supply. ARM-USB-OCD Features - USB 2.0 JTAG dongle interface can be used with all ARM devices for programming and debugging
- Standard 2x10-pin ARM JTAG connector
- Supports ARM targets working from 2.0V to 5.0V DC
- Supported by open-source OpenOCD debugger software
- Adds virtual RS232 port to your computer with all modem signals, e.g. DTR, DSR, DCD, RTS, CTS, Rx, Tx
- Can be used as power supply with jumper-selectable power output: 5V, 9V and 12V DC (see below)
- Dimensions: 50 x 40 mm (2 x 1.6") + 20cm (8") JTAG cable + 30cm (12") power supply cable
 The included CD contains a Windows installer for full-featured and open-source tools: GCC C compiler, OpenOCD debugger and Eclipse IDE. Power Supply Function USB source current is limited with a resettable fuse at 300mA. The maximum current varies depending on the voltage output selected: 5V/200mA, 9V/100mA, 12V/70mA. This also depends on your USB host's current capabilities. If other USB devices are attached to your computer, or if it's a laptop running on batteries, these figures may be different and can vary between USB hosts. Download ARM-USB-OCD Datasheet (PDF file; 62KB) Ships from: USA
Leadtime: In stock
Optional Recommended Products for this Item
|
