With the Pi module made by AK-NORD, a subsequent connection of serial terminals to LAN, ISDN or Bluetooth can be easily performed. The RS232/V24 or an internal RS485 interface are offered in the device. Only a small outlet of 64 x 20 mm is required in order to plug the Pi modules in the terminals. The Pi modules are fixed with two screws and internally supplied with a tension of 6 to 40 volts.

Power supply

• 6-40 Volt

Dimensions

• 64 mm x 82 mm

Connectos

• 9pin Sub-D Plug

Functions

• Modem - Emulation
• ConnectOnData

Supported Profiles

• GAP (General Access Profile)
• SDP (Service Discovery Profile)
• SPP (Serial Port Profile)

Serial Interface

• RS232/V24
• Speed 300Baud -230KBit
• 7-8Bit,Odd-Even parity
• Signals: TXD, RXD, RTS, CTS, DSR, DTR, DCD, GND

Reach

• Class 1 up to 100m

Downloads

Note: The DIN Rail RS232/485 Network Module has a screw terminal power connector. The power supplies offered below as an add-on option do not directly connect. You will have to cut off the supply's barrel connector and then insert the wires into the screw terminal.