The Pro Micro is similar to the Pro Mini except with an ATmega32U4 on board instead of an ATmega328. The 32U4 has a USB transceiver built in, allowing USB connectivity on board. Thus the Pro Micro also adds a micro-USB connector.
This tiny board has familiar Arduino features: four channels of 10-bit ADC, five PWM pins, 12 DIOs, as well as hardware serial connections Rx and Tx.
This is the 5V version which runs at 16 MHz. There is a voltage regulator on board so it can accept voltage up to 12V DC. If you're supplying unregulated power to the board, be sure to connect to the RAW pin — not to VCC.
Board Dimensions: 1.3 × 0.7 inches.
Note: The micro-USB connector is soldered on the board — not through it. Be gentle when plugging and unplugging your USB cable. You might consider adding a dab of adhesive to strengthen the connector's bond with the PCB.
Arduino Pro Micro 5V Board Features
- ATmega32U4 running at 5V / 16MHz
- Supported under Arduino IDE v1.0.1
- On-Board micro-USB connector for programming
- 4x 10-bit ADC pins
- 12x Digital I/Os (5 are PWM capable)
- Rx and Tx Hardware Serial Connections
Arduino Pro Micro 5V Board Resources
Optional Recommended Products for this Item
|USB 2.0 Cable, 6ft. A-Male / Micro-USB (5-pin) B-Male||+|| US$6.00|
|Rectangular Pin Header, Male, 1x40 Single Row, 2.54mm Spacing||+|| US$0.75|
|Pack of 12 Prototyping Wires for 0.025-inch Square Pins||+|| US$6.90|
|Jumper Wires, M-F, 5" (Qty 10) and 40-pin Header||+|| US$6.00|
|Jumper Wires, Premium, M-M, 155mm (Qty 10), 2 ea. @ 5 colors||+|| US$3.95|