The DAISY-30 module provides an interface to XBee modules so that they can be controlled by the FOX Board G20 via the DAISY-1 Adapter, or by the Terra Board.
An XBee module is not included. The picture shows one simply to show the correct orientation.
This module can plug into the following Daisy ports on the DAISY-1 Adapter (Fox) or Terra Board:
|Daisy port ||Serial devices ||Signals available |
|FOX D1 ||/dev/ttyS2 ||TXD, RXD, RTS, CTS |
|FOX D3 ||/dev/ttyS1 ||TXD, RXD, RTS, CTS |
|FOX D6 ||/dev/ttyS4 ||TXD, RXD, RTS, CTS |
|FOX D8 ||/dev/ttyS3 ||TXD, RXD |
|TERRA D10 ||/dev/ttyS4 ||TXD, RXD, RTS, CTS |
|TERRA D13 ||/dev/ttyS2 ||TXD, RXD, RTS, CTS |
Be sure to get a 0.05" pitch 2x5 IDC cable (FC-19818-10P-FF) to make the connection. The cable is not included.
The Daisy connection to the Fox/Terra board provides the XBee communication pins (3V3, TX, RX, RTX, CTS, DTR, RST, GND). The DAISY-30 module board also has 10 through-hole pads that break out additional pins of the XBee module (3V3, D0-D4, Sleep, PWM1, VREF, GND).