This Philips LPC210x Starter Kit provides a complete environment in which you can develop your programs for the Philips LPC210x family of ARM processors, and even drive a legacy 8051 board. The SE-ARM-P target board is fully supported by the Philips ISP Flash programming software, and ships with an LPC2103 microcontroller fitted in a clamshell socket so that you swap in any other LPC210x MCU easily. Jumper settings allow you to configure the JTAG connector for LPC2101/2/3 or LPC2104/5/6 operation. As well as status LEDs, the board has 32 LEDs on the port pins.
Philips LPC210x Starter Kit Contents
Download board schematic
- SE-ARM-P target board
- Serial cable to connect the board to your PC
- Power supply and cable
- 32kB-limited evaluation version of the Crossware ARM Development Suite which includes ANSI C Compiler, Assembler, Simulator, Debugger, Code Creation Wizards, IDE and on-line manuals
- Header cable to connect the board to a 40-pin DIL 8051 socket allowing you to run an 8051 board with the ARM chip
- Printed Getting Started guide
Optional Debugger & Programmer
The Crossware Jaguar USB JTAG interface is designed to facilitate on-chip ARM debugging. It connects to the standard 20-pin ARM JTAG connector, allowing the Crossware source-level debugger to drive the on-chip ARM embedded in-circuit emulator (EmbeddedICE) logic.
Country of Origin: United Kingdom
Leadtime: 1 day