Integrated MAC and 10/100Base-T PHY Hardware security acceleration engines Factory-preprogrammed unique MAC address Support for pause control frames, including automatic Transmit and Receive flow control Supports half- and full-duplex operation Programmable automatic retransmit-on-collision The mikroETH100 Board pushes the boundaries of speed and flexibility in Ethernet applications. The board has Microchip's ENC624J600 10/100 Base-T Ethernet controller with integrated MAC & PHY, hardware cryptographic security engines, and a factory-programmed unique MAC address. Communication is done using fast 8-bit or 16-bit multiplexed or demultiplexed parallel interface. Jumpers on the board allow you to select between eight different Parallel Slave Port interface modes. Connection to your microcontroller system is established via two 2×11-pin interfaces with standard 0.1" spacing. Nothing is soldered on the pads, so you can install a socket or pins depending on your application. Male pin headers are included loose. Note: This board uses 3.3V power supply only. Be sure to use voltage translators on communication lines when connecting it to 5V systems. 100Mbps Ethernet Board Resources
Optional Recommended Products for this Item
|
