Go to ARM Development Suite order page Atmel AT91SAM9263 is supported, as follows: AT91SAM9263Graphical Code Creation Wizards:- Controller Area Network (CAN)
- Chip Configuration
- LCD controller
- Bus matrix
- Pulse width modulator (PWM)
- Periodic interval timer (PIT)
- Ports (PIOA, PIOB, PIOC, PIOD and PIOE)
- Power management controller (PMC)
- Reset controller
- SDRAM controllers (SDRAMC0 and SDRAMC1)
- Static memory controllers (SMC0 and SMC1)
- Serial peripheral interfaces (SPI0 and SPI1)
- Synchronous serial controllers (SSC0 and SSC1)
- System interrupt
- Timer/counters
- Two-wire interface (TWI)
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)
- USB device port (UDP)
- Watchdog timer
Context menu Code Creation Wizards: - 2D graphics controller
- AC97 audio interface
- Advanced interrupt controller (AIC)
- Controller Area Network (CAN)
- Chip configuration
- Debug unit
- DMA controller (DMAC)
- Error-corrected code (ECC0 and ECC1)
- Ethernet MAC (EMAC)
- Image sensor interface
- Bus matrix
- MultiMedia Card interfaces (MCI0 and MCI1)
- Pulse width modulator (PWM)
- Periodic interval timer (PIT)
- Ports (PIOA, PIOB, PIOC, PIOD and PIOE)
- Power management controller (PMC)
- Reset controller
- Real-time timers (RTT0 and RTT1)
- SDRAM controllers (SDRAMC0 and SDRAMC1)
- Shutdown controller
- Static memory controllers (SMC0 and SMC1)
- Serial peripheral interfaces (SPI0 and SPI1)
- Synchronous serial controllers (SSC0 and SSC1)
- System interrupt
- Timer/counters
- Two-wire interface (TWI)
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)
- USB device port (UDP)
- Watchdog timer
Source-level ARM instruction set simulation Simulation of the memory management unit (MMU) and fast context switch extension (FCSE) Peripheral simulation: - PLL
- Advanced interrupt controller
- Ports
- Timer/counters
- Universal synchronous/asynchronous receiver/transmitters (USART0, USART1 and USART2)
Source-level on-chip debugging with included Jaguar USB JTAG interface - Automatically detects boot mode and configures SRAM or programs Flash
- Debugging with the memory management unit (MMU) and fast context switch extension (FCSE) enabled
Go to ARM Development Suite order page
|